Single ferrule connector assembly ● Install an appropriate length of seamless steel saws to remove the burr at the port. To end face perpendicular to the axis of the tube, angle tolerance is not greater than 0.5 °. If you need to bend the pipe, from the end face of the tube to the curved parts of the line segment length can not be less than three times the length of the nut. 2 nut and a condom on seamless steel tubes. Note nut and ferrule direction, not installed backwards. 3 In the pre-assembled connector body and cards put on greased thread, the tube into the connector body, (the tube must be inserted in the end) Tighten the nuts by hand. 4 Tighten the nut until the ferrule stuck pipe, the turning point in the tightening torque can be increased by feel (pressure points). 5 After reaching the pressure point, and then tighten the compression nut 1/2 turn. 6 pre-assembled connector body is removed, embedded case examination ferrule fittings blade edges, protrusions visible space must be filled with a ferrule end face. Card sets can be rotated slightly, but not axial goes. 7 final installation, screw Lubricate the actual installation of the connector body, tighten the compression nut and match to increase the perceived tightening force so far. Then tighten 1/2 turn installed. Ferrule connectors have a solid connection, high voltage capability, sealing, and repetition is good, easy installation and maintenance, safe and reliable works: the steel insert card kit, use the card sleeve nut, ferrule conflict , cut the pipe and seal. Nominal: 2.5-16Mpa Applicable temperature: ≤150 ℃ Size: thread edge specifications: 1 / 4,1 / 8,3 / 8 fittings specification model 1 / 2,3 / 4,1 "card sets edge specifications: Ф6 fittings manufacturer, Ф8, Ф10, Ф12, Ф14, Ф16, Ф18, Ф20, Ф22 Suitable medium: water oil ﹑ ﹑ gas and some corrosive liquid ferrule connectors for use as a to transition parts, you need to be very effective noise isolation and a more well compensated bit operation, so that it can be performed even better in connectors. fittings offer, Zhenjiang City, Wal electric meter (already certification), fittings provided by Zhenjiang City Wal instrument Equipment Co., Ltd. Zhenjiang City, Wal instrument Equipment Co., Ltd. (www.zjjwdy.com) is a leader in Zhenjiang, Jiangsu Province, transmission equipment and materials over the years, the company implementing the implementation of scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In Wolfowitz electric meter leadership with the staff warmly welcome all inquiries negotiations to create Wolfowitz electric meter a better future.